Abstract
A modified self-piercing rivet (SPR) has been proposed to mechanically fasten CFRP laminates. The modified SPR consists of a rivet body and two flat washers. The two flat washers were used to suppress delamination in the CFRP laminates at the point of piercing. The advantages of the modified SPR for fastening CFRP laminates are instantaneous process time and low cost. Any pretreatments such as surface treatments or hole drilling are not required. In this study, the viability of the modified SPR for a quasi-isotropic CFRP laminate was investigated by tensile and fatigue tests on the single lap joints. The experimental results showed that the tensile strength of a modified SPR joint was slightly higher than a bolted joint. In tension–tension fatigue tests, a fatigue limit at Nf=107 cycles was about 50% of the tensile joint strength. Experimental results showed that the modified SPR was one of the promising fasteners for future mass-production CFRP automobiles.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
