Instant formation of nanopores on flexible polymer membranes using intense pulsed light and nanoparticle templates

Abstract

ABSTRACT The development of simple and high-throughput approaches to yield solid-state nanopores on large surface membranes may facilitate the prevalence of nanopore analysis technology and in-vitro diagnosis using portable devices. However, solid-state nanopores are typically realized by complex and high-end nanofabrication equipments. Here, we present a method to achieve nanopores on polymer membranes using silver nanoparticles (AgNPs) as templates and intense pulsed light (IPL) as a heating source. The density and size of nanopores are controllable by adjusting the spin coating rate, the concentration of nanoparticle suspension, and the size of nanoparticles (NPs). The temperature of the AgNPs can rapidly reach 1132 K under instant heating of photothermal effect through light irradiation in 2 ms, resulting in localized melting and decomposition of an underneath polycarbonate (PC) membrane to yield nanopores with sizes ranging from 10 to 270 nm. After removing the nanoparticle residues, the flexible membrane with nanopores can be integrated into a flow cell to achieve a nanopore sensor that has been used to measure the translocation behaviors of bovine serum albumin (BSA). The results have demonstrated the capability of the sensor in protein denaturation identification. This low-cost and high-throughput technique to fabricate solid-state nanopores on flexible polymeric membranes may facilitate the development of more nanopore-based flexible sensors that can be integrated with other flexible components for wearable diagnosis.