Abstract
An in-situ sensor, based on Electrochemical Impedance Spectroscopy (EIS), has been used to monitor the health of adhesive bonds constructed from various combinations of aluminum, graphite/epoxy, glass/epoxy, glass/polyester, and glass/vinylester composites and exposed to high humidity and temperature conditions. Modeling of the EIS data as an electric circuit demonstrated that several circuit parameters of the impedance spectra were sensitive to bond performance, as determined by wedge tests and lap shear tests. Moisture absorption by the adhesive and composite was calculated from the circuit capacitance, which was also a function of bonded area and bondline thickness (bondline + composite thickness for glass composites). Material differences, including saturation level of moisture, rate of absorption, and bondline stability, were readily seen among the various materials sets. The sensor electrodes are attached to opposite sides of a bond after fabrication, i.e. they are not embedded. Thus, they are suitable for monitoring existing bonded structures. They have the potential to identify bondlines that are in the early stages of degradation, prior to significant loss of bond strength. As an input to a condition-based maintenance system, they would identify weakening bondlines and allow preventative action to be scheduled and performed.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
