In-situ preparation of lactate-sensing membrane for the noninvasive and wearable analysis of sweat

Abstract

In the wearable electrochemical biosensors, sensing signal duration is significantly dependent on the long-term stability of functional materials modified on the flexible substrate, the effect of pH changes of sweat on the sensing device and signal fluctuation caused by the bending of sensor. Here, we proposed a wearable biosensor based on the lactate-sensing membrane mainly constituted by Prussian blue (PB), reduced graphene oxide (rGO), Au nanoparticles and lactate oxidase (LOx). Based on the in-situ layer-by-layer spin-coating preparation method, the electrode surface was covered with an extensive and uniform PB/GO membrane with a high stability. After the electro-reduction of GO to rGO and the combination of urchin-like Au particles with sufficient tentacles to LOx, the sensing membrane showed the improved electron transport from the enzyme active center to the electrode. Therefore, the wearable biosensor achieved a high sensitivity of 40.6 μA mM−1 cm−2 in a range of 1–222 μM and a low sensitivity of 1.9 μA mM−1 cm−2 in a wide range of 0.222–25 mM, satisfying the requirement of the typical test. In addition, with the excellent running and mechanical stability, the lactate biosensor was successfully applied on volunteers’ skin for real-time monitoring of perspiration in vivo. The results were comparable with ex vivo measurements achieved by a commercial lactate sensor. The wearable electrochemical biosensor provides a good candidate in the future for the evaluation of human sweat in sports and biomedical fields.