Abstract
Composites of Poly(lactic acid) (PLA) and spherical zinc oxide (ZnO) nanoparticles were prepared using melt processing followed by injection molding. The effect of nanosized ZnO on the molecular structure, thermal properties, dynamic mechanical properties, and flow characteristics of PLA composites were analyzed. Scanning electron microscopy images illustrated the formation of ZnO aggregates through PLA matrix. The molecular weight of PLA‐ZnO experienced a substantial decline by 55%, suggesting the presence of ZnO provoked degradation of PLA during composite preparation. Glass transition temperature of PLA‐ZnO decreased by 18% as compared with pure PLA, confirming the deleterious role of ZnO in PLA. The ZnO nanoparticles acted as a reactant and increased the thermal degradation rate. However, the incorporation of ZnO into PLA increased the crystallinity up to 20% and the storage modulus of composites in glassy state by 10%. The higher peak value of tan δ in composites suggested the more viscous behavior, which was further supported by lower number average molecular weight. The complex viscosity of composites exhibited a large Newtonian region over low shear rate, followed by shear thinning phenomenon. A significant decrease (96%) in complex viscosity was observed with the addition of ZnO into PLA. POLYM. ENG. SCI., 59:1242–1249 2019. © 2019 Society of Plastics Engineers
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
