Abstract
Drawing process is generally influenced by many technological parameters (e.g. holding pressure, friction coefficient, etc.) and all of them should be considered for numerical simulation of such process. This paper deals with the possibilities how to determine one of the parameters that is quite difficult to be taken into account - magnitude of heat generated during forming process. In this case only heat generated by plastic deformation was determined, thus static tensile test at different loading rates was performed. Contact-less optical system ARAMIS and Thermo-camera FLIR SC660 was used to measure distribution of both plastic deformation and temperature on samples surfaces.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
