Abstract
The influence of surface treatment and design of cathode flow fields in direct methanol fuel cells was investigated by in-plane neutron radiography and measurements of cell performance and pressure drop along the cathode channels. A specially designed test cell and neutron radiography set-up allows for studying the water distribution in an in-plane viewing direction. A temporal resolution of down to 10 s was used while an image resolution of approximately 80 μm could be obtained. The cathode flow fields were either impregnated by a hydrophobizing or hydrophilizing agent or left untreated. It turned out that hydrophobic channel walls lead to the formation of large water droplets, which partially block the air flow in the cathode channels. Their periodical growth and discontinuous removal leads to an unstable and fluctuating operation. Hydrophilized cathode flow fields, on the other hand, ensure a stable operation due to removal of excess water by a continuous water film. Two different cell designs including untreated cathode flow fields with either dual-channel or grid design were compared. The grid flow field was superior with regard to the stability of cell performance and less prone to the formation and removal of water droplets.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.