Abstract
Appropriate and rational management of the energy produced by renewable energy sources is one of the most urgent challenges for the global energy sector. This paper is devoted to the systematic experimental and theoretical studies of a modular solar charger based on silicon and dye-sensitized solar cells as an energy source, and supercapacitor as an energy bank. Using the MathCAD program, I–V characteristics were plotted for both a single cell and a photovoltaic module based on various series-to-parallel connections. To assess the surface quality of the modules, additional tests using a thermal imaging camera were carried out as well. The charging characteristics of the supercapacitor (two series-connected cells with a capacity of 300 F), were determined depending on the parameters of the photovoltaic module as well as considering the influence of the voltage balancing system and control system. The charge, discharge, and recharge characteristics were carefully analyzed to optimize the operating conditions, i.e. the number of photovoltaic cells. To evaluate the stability of parameters with operation time, and their temperature dependence (17–65 °C), solar modules were tested for ten days under Central European weather conditions. Importantly, a comparative analysis of solar chargers based on different configurations of photovoltaic cells showed an increase in electrical parameters for the proposed modular inorganic–organic concept compared to dye-sensitized solar cells produced alone on a rigid substrate. Finally, preliminary assumptions (requirements) were developed regarding the electrical and optical parameters for new dye-sensitized solar cells that could be used in the innovative solar charger instead of silicon cells along with a predicted role of artificial intelligence (AI) in these devices.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have