Innovative reinforcement method for metal foam cell wall using CNTs.

Abstract

Carbon nanotubes (CNTs) and their composites are gaining popularity due to their exceptional strength qualities. It is well known that adding carbon nanotubes to metal foam composites boosts compressive strength. On the other hand CNT addition is still a costly process due to high cost of the CNTs. This study presents a novel and cost-effective solution by selectively adding CNTs to the structurally weakest regions of aluminum foam materials produced via powder metallurgy, employing a newly developed focused multi-step additive method. The cell borders of aluminum foam are strengthened with multiple spherical layers of CNTs, using a transfer method by initially coating the space holders used at the foaming process. The strength increase effect of this CNT addition method was compared with the widely known aluminum foam production parameters via a 4-parameter design of experiment (DOE) study. Compressive strength values of the samples were evaluated using a constant speed compression test acc. to ISO13314. The compacting pressure, CNT concentration, sintering temperature, and sintering period were chosen as design of experiment parameters, and 78% of the interactions effecting on final compressive strength could be explained with the model. As a result, it was established that, compared to the other parameters, sintering duration had the highest influence on compressive strength. But besides It has also been shown that adding 0.53% CNT by weight only to the cell border regions increases overall strength by 9%. This weight-strength increase ratio is compared with similar studies in the literature and found to be providing a production cost advantage due to the lower amount of CNT addition requirement for the comparable weight relative strength increase. Focused strength increase method has potential to enable controlled failure of foam materials by selectively strengthening strength critical areas of a component.