Abstract
Abstract Fan-Out Wafer Level Packaging (FOWLP) has been established as one of the most versatile packaging technologies in the recent past and already accounts for a market value of over 1 billion USD due to its unique advantages. The technology combines high performance, increased functionality with a high potential for heterogeneous integration and reduced overall form factor as well as cost effectiveness. The increasing complexities in achieving a higher degree of performance, bandwidth and better power efficiency in various markets are pushing the boundaries of emerging packaging technologies to smaller form factor packaging designs with finer line/width spacing as well as improved thermal/electrical performance and the integration of System-in-Package (SiP) or 3D capabilities. SiP technology has been evolving through utilization of various package technology building blocks to serve the market needs with respect to miniaturization, higher integration, and smaller form factor as cited above, with the added benefits of lower cost and faster time to market as compared to silicon (Si) level integration, which is commonly called system-on-chip or SoC. As such, SiP incorporates flip chip (FC), wire bond (WB), and fan-out wafer-level packaging (FOWLP) as its technology building blocks and serves various end applications ranging from radio frequency (RF), power amplifiers (PA), Micro-Electro-Mechanical-Systems (MEMS) and Sensors, and connectivity, to more advanced application processors (AP), and other logic devices such as graphics processing units (GPUs)/central processing units (CPUs). FOWLP, also referred to as advanced embedded Wafer Level Ball Grid Array (eWLB) technology, provides a versatile platform for the semiconductor industry's technology evolution from single or multi-die 2D package designs to 2.5D interposers and 3D SiP configurations. This paper presents developments in SiP applications with eWLB/Fan-out WLP technology, integration of various functional blocks such as wire bonding, Package-on-Package (PoP), 2.5D, 3D, smaller form factor, embedded passives, multiple redistribution layer routing and z-height reduction. Test vehicles have been designed and fabricated to demonstrate and characterize these low profile and integrated packaging solutions for mobile products including Internet of Things (IoT)/wearable electronics (WE), MEMS and sensors. Finer line/width spacing of 2/2mm with multiple redistribution layers (RDL) are fabricated and implemented on the eWLB platform to enable higher interconnect density and signal routing. Assembly process details, component level reliability, board level reliability and characterization results for eWLB SiP will be discussed.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.