Inkjet-printed heater on flexible substrates for low voltage applications

Abstract

Flexible heaters (FHs) have applications ranging from defoggers to flexural warmers, food processors, and thermotherapy. Printed FHs are particularly of interest as they offer unique advantages like high resolution, customization, low cost, and ease of fabrication. Here, we report printed FHs on polyethylene terephthalate substrate. The heater design is optimized to operate on a low voltage of five volts and yield high temperatures with a uniform temperature distribution across the surface. The heater has a fast response time of 15 s to reach its maximum temperature and does not show any degradation in performance after three months of operation. The heater maintains its temperature after continuous use for two hours and exhibits a minimum change in temperature upon bending. We have also developed and tested designs for zone heaters and nano heaters, where zone heater is suited for applications requiring heating in specified locations on a surface only. Whereas nano heater has an area of 1 mm2 and can produce high temperatures in this small area. Finally, we developed similar printed heaters on paper and polyimide (PI) substrates as well. Paper-based heater can achieve a temperature of 210 °C and can be used in disposable applications due to its low cost, whereas PI heater can achieve a temperature of 380 °C and is suitable for attaining high temperatures. These results manifest the use of FHs for various practical applications.