Injection Molded Sustainable Biocomposites From Poly(butylene succinate) Bioplastic and Perennial Grass

Abstract

Biocomposites from poly(butylene succinate) (PBS) and perennial grass (miscanthus fibers) were successfully prepared by extrusion and injection molding methods with different fiber loadings. The tensile strength of uncompatibilized PBS/miscanthus composites was much lower compared to that of neat PBS. Unlike tensile strength, the flexural and impact strengths were significantly enhanced after incorporation of miscanthus fibers into the PBS matrix. The enhanced flexural strength was attributed to the reinforcing effect of miscathus fibers. The fiber pull-out mechanism is likely responsible for the observed impact strength improvement. Addition of 5 wt % maleic anhydride (MAH) grafted PBS (MAH-g-PBS) into PBS composites showed a significant improvement in tensile and flexural strength compared to the corresponding uncompatibilized composites and neat matrix. For example, the PBS composites with 50 wt % miscanthus fiber and 5 wt % MAH-g-PBS resulted in 22, 139, and 47% improvements in tensile, flexural, and ...