Abstract

In this work, we study three aluminum oxides (alpha, gamma, boehmite) and various oxidized metallic aluminum powders to observe their dehydration and decomposition behavior using in situ diffuse reflectance infrared Fourier transform spectroscopy (DRIFTS) and scanning electron microscopy (SEM). We find that a temperature increase to the aluminum oxides (aluminas) reduces physically adsorbed water molecules to reveal the presence of hydroxyl groups. All three aluminas contained bridged hydroxyls located at 3670 cm−1; we found additional surface hydroxyls, which varied based on the oxidation state of the aluminum atom. Oxidized metallic aluminum powders that were aged resulted in similar behavior; however, the results differed depending on the method of aging. We find that naturally aged aluminum (NA-Al) powders with heavy oxidation in the form of the tri-hydroxide decomposed and did not reveal any detectable surface hydroxyl peaks. When aged using artificial methods (AA-Al), we find both surface hydroxyls, including bridged hydroxyls at 3670, 3700, and 3730 cm−1, and a remaining boehmite-like surface. These results show that metallic aluminum powders can be tailored for specific applications, regardless of age. It also elucidates different ways to pre-process the powders to control the surface oxide layer, corroborated by comparison with the models oxides studied herein.

Highlights

  • Academic Editor: Aibing YuMetallic aluminum powders have a wide variety of engineering applications, including catalysis [1–3], propulsion [4–6], pigments [7,8], and as foaming agents [9]

  • The alumina powders will serve as a reference for the study of the more complex surfaces found on the metallic aluminum powder surfaces using infrared spectroscopy (IR)

  • We reveal the dehydration and decomposition behavior of alumina and metallic aluminum powders using in situ diffuse reflectance infrared Fourier transform spectroscopy (DRIFTS)

Read more

Summary

Introduction

Academic Editor: Aibing YuMetallic aluminum powders have a wide variety of engineering applications, including catalysis [1–3], propulsion [4–6], pigments [7,8], and as foaming agents [9]. The particle surface properties are fundamental to understanding how the powders will perform in filling, spray, and composite applications To this end, we study the surface properties and thermal behavior of both alumina and metallic aluminum powders to better understand their as-received and dried state behavior. We hope to fill an important knowledge gap to help researchers identify the initial state, dehydration, and decomposition properties of aluminum powders in wide variety of states using a simplistic IR setup. This allows for the easy identification of the oxide (Al2 O3 ), oxy-hydroxide (AlO(OH)), and hydroxide (Al(OH)3 )

Methods
Results
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call