Abstract
Friction stir processing (FSP) was used to fabricate Al/Cu metal matrix composite (MMC). The effects of two different tool pin profiles (straight cylindrical and square) and the number of FSP passes on microstructure, tensile properties and microhardness were studied. The results indicated that good dispersion of micro-sized Cu particles, finer grains, higher tensile properties and higher microhardness, can be achieved by the square tool pin profile compared to the samples produced by the other tool. Also it was observed that the ultimate tensile strength of the samples produced by two FSP passes, as a result of Cu particles shattering, increased intensively compared to the samples fabricated with first FSP pass. Further FSP passes increased the elongation of the composites without any considerable changes in yield and ultimate tensile strength.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
