Abstract
It has been well known that some carbohydrates have a injurious effect on the hydration of portland cement. Succharose, for example, acts as a retarder when present in low concentrations, but accelerates set (temporarily occurs the flash set in the strict sence of the word) when used at higher concentrations. Moreover, the development of the compressive and bending strength is lowered with the increase of the concentration of succharose, and the hardening of portland cement mortar and concrete are impossible over a few months in such higher concentrations as the flash set happens.There are many reports about the above mentioned actions of succharose on the hydration of portland cement, but is something to be investigate.Authors investigated the hydration of portland cement and clinker minerals from several points of view in the presence of succharose, d-glucose and dextrin, and obtained the results as following.(1) Influences of d-glucose on the setting and hardening of portland cement are similar to that of succharose, and dextrin has also slightly similar action to the latters.(2) The possible explanation of the flash set, which occur in higher concentrations of succharose, may be that a large amounts of gel-like lime-ssuccharose compound and aluminum hydroxide are produced by chemical reaction between succharose and tricalcium aluminate and occurs “gel set” by sudden coagulation.The precipitation of insoluble compounds, which may be trilime-monosuccharate and higherlime-monosuccharate produced by the reaction between succharose and surface of alite particle and lime in a aq. solution, plays an important role in retarding the development of mechanical strength.The retarding action of succharose and d-glucose etc. on the hydration of alite increase consistently with the increse of its concentrations.(3) α-d-methylglucosid, which is produced by the reaction of H3C- with “reducing carbon” group of glucose, does not react with lime, therefore, has only a little effect on the hydration of portland cement clinker minerals in relatively higher concentrations.(4) The mechanism of the hydration of alite, with or without carbohydrate, are investigated by the analyzing of the heat liberation curves which were derived from hydration of alite in devised adiabatic calorimeter. The proposed mechanism shall be that hydration of alite consists of three possible processes, namely, the first process is the dissolution of alite, the second is the sprightly formation of calcium silicate hydrates and the last is diffusion process of hydration. These processes occurs orderly and continuously, and initial and final parts of each process overlap mutually.The dissolution process is hastened by the rising of hydration temperature and addition of the accelerating reagents, on the contrary, is prolonged by the protective coating formation of gel-like lime-succharose compound on the surface of alite particles. The second process continue until the hydration rate of alite reach near 40% and after all the hydration reaction are obedient to diffusion process.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.