Influences of heating temperatures on physical properties, spray characteristics of bio-oils and fuel supply system of a conventional diesel engine

Abstract

Alternative fuels need to satisfy the strict requirements of the use for diesel engines aiming at enhancing the performance and reducing pollutant emissions. The use of straight bio-oils for diesel engines entails improving their disadvantages such as high density, high surface tension and kinematic viscosity (tri-physical parameters). There have been some as-used methods for reduction of the above-mentioned negative effects related to straight bio-oil disadvantage, however, the adequately-heating method may be considered as a simple one helping the physical parameters of straight bio-oils to reach stable and highly-confident values which are close to those of traditional diesel fuel. As a consequence, the spray and atomization, combustion, performance, and emissions of diesel engines fueled with preheated bio-oils are improved. In this work, a study of the dependence of the density, surface tension and kinematic viscosity of coconut oil (a type of bio-oils) on temperatures (from 40-110oC) within a wide variety are conducted. In the first stage, the influence study of temperature on tri-physical parameters is carried out on the basis of experimental correlation and as-described mathematical equation. In the second stage, the influence study of tri-physical parameters on spray and atomization parameters including penetration length (Lb) and Sauter mean diameter (SMD), and the influence of tri-physical parameters on fuel supply system are investigated. The optimal range of temperature for the as-used bio-oils is found after analyzing and evaluating the obtained results regarding the physical properties and spray characteristics, as well as compared with those of diesel fuel. The confident level over 95% from the regression correlation equation between the above-mentioned tri-physical parameters and temperature is presented. Additionally, the measured spray parameters, the calculated values of frictional head loss and fuel flow rate are thoroughly reported.