Abstract
Sintering aids are widely used to promote densification and grain growth for electrolytes based on yttriumdoped barium zirconate. However, there are some discrepancies in the literature about the influence of these sintering aids on the microstructure development. Some authors consider that ZnO remains on grain boundaries, forming an amorphous phase that promotes sintering, and others proposed that ZnO forms a solid solution with barium zirconate. Even considering different mechanisms, it was proposed that ZnO addition compromised protonic conductivity. In this work BaZr0.8Y0.2O3-? (BZY20) was prepared by conventional oxide mixture (solid state sintering), adding ZnO as sintering aid. We proposed a mechanism for the ZnO actuation on the microstructure development, by the formation of a liquid phase during sintering and formation of a vitreous phase throughout grain boundaries during cooling. This could be the reason for poor protonic conductivity in comparison to the undoped BZY20 electrolytes. The proposed mechanism was established through the scanning electron microscopy analyses and electrical conductivity measurements under several different atmospheres by impedance spectroscopy. High density samples were obtained by using ZnO, but with compromised electrical conductivity compared to the undoped samples.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.