Abstract

Antireflection coatings (ARCs) with an indium thin oxide (ITO) layer on silicon heterojunction solar cells (SHJ) have garnered significant attention, which is due to their potential for increasing current density (Jsc) and enhancing reliability. We propose an additional tungsten trioxide (WO3) layer on the ITO/Si structure in this paper in order to raise the Jsc and demonstrate the influence on the SHJ solar cell. First, we simulate the Jsc characteristics for the proposed WO3/ITO/Si structure in order to analyze Jsc depending on the thickness of WO3 using an OPAL 2 simulator. As a result, the OPAL 2 simulation shows an increase in Jsc of 0.65 mA/cm2 after the 19 nm WO3 deposition on ITO with a doping concentration of 6.1 × 1020/cm2. We then fabricate the proposed samples and observe an improved efficiency of 0.5% with an increased Jsc of 0.75 mA/cm2 when using a 20 nm thick WO3 layer on the SHJ solar cell. The results indicate that the WO3 layer can be a candidate to improve the efficiency of SHJ solar cells with a low fabrication cost.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.