Abstract

Two series of new photocatalysts were synthesized based on modification with Pd of the commercial P25 photocatalyst (EVONIK®). Two techniques were employed to incorporate Pd nanoparticles on the P25 surface: photodeposition (series Pd-P) and impregnation (series Pd-I). Both series were characterized in depth using a variety of instrumental techniques: BET, DRS, XRD, XPS, TEM, FTIR and FESEM. The modified series exhibited a significant change in pore size distribution, but no differences compared to the original P25 with respect to crystalline phase ratio or particle size were observed. The Pd0 oxidation state was predominant in the Pd-P series, while the presence of the Pd2+ oxidation state was additionally observed in the Pd-I series. The photoactivity tests were performed in a continuous photoreactor with the photocatalysts deposited, by dip-coating, on borosilicate glass plates. A total of 500 ppb of NO was used as input flow at a volumetric flow rate of 1.2 L·min−1, and different relative humidities from 0 to 65% were tested. The results obtained show that under UV-vis or Vis radiation, the presence of Pd nanoparticles favors NO removal independently of the Pd incorporation method employed and independently of the tested relative humidity conditions. This improvement seems to be related to the different interaction of the water with the surface of the photocatalysts in the presence or absence of Pd. It was found in the catalyst without Pd that disproportionation of NO2 is favored through its reaction with water, with faster surface saturation. In contrast, in the catalysts with Pd, disproportionation took place through nitro-chelates and adsorbed NO2 formed from the photocatalytic oxidation of the NO. This different mechanism explains the greater efficiency in NOx removal in the catalysts with Pd. Comparing the two series of catalysts with Pd, Pd-P and Pd-I, greater activity of the Pd-P series was observed under both UV-vis and Vis radiation. It was shown that the Pd0 oxidation state is responsible for this greater activity as the Pd-I series improves its activity in successive cycles due to a reduction in Pd2+ species during the photoactivity tests.

Highlights

  • The continuing deterioration of the environment is a problem that has been acquiring ever greater relevance over the last few decades

  • Taking as a starting point the knowledge acquired from these studies, this work evaluates the incorporation of Pd on TiO2 by impregnation and photodeposition for NOx removal at 500 ppb concentration, at a temperature of 25 ◦C and with and without humidity

  • Identification is made through infrared spectroscopy of the species that are formed in NOx oxidation, and the influence of the water and palladium species on reactivity is discussed

Read more

Summary

Introduction

The continuing deterioration of the environment is a problem that has been acquiring ever greater relevance over the last few decades. Some publications have focused very on the synthesis of new materials modified with Pd [21,22], but without placing any importance on their reactivity, while others [14,23,24] have tested modified commercial materials under very specific conditions—including some not very common values for these conditions of radiation, temperature, humidity and NO concentrations. We consider that this present work constitutes an extension and completion of these previous studies. This comprises one of the major goals of this study since photocatalyst reuse is one of the issues that need to be solved for the practical application of this technology

Synthesis of Photocatalysts
Dip Coating
Analysis Techniques
Photoactivity Study
Results
Influence of Palladium Oxidation State
Conclusions
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call