Influence of various surfactants on the stability and solidification characteristics of DI water-based CuO NFPCM for cool thermal energy storage system

Abstract

The current study goals to investigate the stability and solidification characteristics of deionized water (DI water) based copper oxide (CuO) nanofluid phase change materials (NFPCMs) with a nucleating agent, different types of surfactants (SBDS, CTAB, and GA) and different weight concentration of surfactant for cool thermal energy storage systems (CTES). The stability of NFPCMs was assessed through average particle size distribution, zeta potential, and UV–vis absorbance. Among all NFPCMs, 0.1 wt% SDBS - CuO NFPCM showed prolonged stability with −42.7 mV and 212.6 nm of zeta potential and average particle size value. The heat transfer properties of NFPCMs were studied with differential scanning calorimetry (DSC), Thermogravimetric analysis (TGA) and thermal conductivity measurements. The introduction of 0.05 wt% SDBS to NFPCM resulted in a notable 17.84 % and 7.64 % increase in thermal conductivity in solid and liquid states, with a slight decrease in latent heat by 5.2 % and 6.01 % during melting and crystallization as compared to DI water. The solidification experiments of NFPCMs were investigated in a spherical encapsulation at a surrounding bath temperature of −8 °C and − 10 °C. Comparing various surfactants in NFPCMs, the SDBS–CuO NFPCM was the most efficient in reducing the solidification time by 26.3 % and 28.4 % at −8 °C and − 10 °C respectively, compared to the nucleating agent PCM (NAPCM). Further, the different concentrations of SDBS in NFPCM demonstrated that 0.05 wt% SDBS–CuO NFPCM displayed the greatest reduction in solidification time, achieving 29.4 % and 27.7 % at −10 °C and − 8 °C, respectively, compared to the NAPCM.