Abstract
Abstract The predictive quality of numerical simulations for mechanical joining processes depends on the implemented material model, especially regarding the plasticity of the joining parts. Therefore, experimental material characterization processes are conducted to determine the material properties of sheet metal and generate flow curves. In this regard, there are a number of procedures which are accompanied by varying experimental efforts. This paper presents various methods of determining flow curves for HCT590X as well as EN AW-6014, including varying specimen geometries and diverse hardening laws for extrapolation procedures. The flow curves thus generated are compared considering the variety of plastic strains occurring in mechanical joining processes. The material data generated are implemented in simulation models for the joining technologies, clinching and self-piercing riveting. The influence of the varied methods on the predictive accuracy of the simulation model is analysed. The evaluation of the differing flow curves is achieved by comparing the geometric formation of the joints and the required joining forces of the processes with experimentally investigated joints.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
