Influence of tin additions on the corrosion passivation of TiZrTa alloy in sodium chloride solutions

Abstract

Abstract In this study, the fabrication of Ti-12%Zr-4%Ta-2%Sn alloy, Ti-12%Zr-4%Ta-4%Sn alloy, and Ti-12%Zr-4%Ta-6%Sn alloy using powder metallurgy fabrication technique has been carried out. The influence of Sn addition on the corrosion of these alloys after 30 min and 3 days in 3.5% NaCl solution using various techniques has been reported. The Nyquist spectra revealed that boosting Sn content from 2 to 4% and further to 6% increases the corrosion resistance of the alloy through increasing the diameter of the obtained semicircle. Bode spectra also elucidated that the increased percentage of Sn increases the values of the impedance of the interface |Z| and the maximum degree of the phase angle (Φ). It was indicated from the cyclic polarization curves that the increased Sn content increases the passivation of the alloy through decreasing its rate of corrosion and increasing its corrosion resistance. The measured current over time at −0.10 V showed that the alloy with low Sn content, 2%, records the highest currents, which pronouncedly decreases when Sn content increases to 4% and further to 6%. Prolonging the time of exposure from 30 min to 3 days greatly enhances the passivation of the TiZrTaSn alloys due to the formation of mixed oxides of TiO2, ZrO2, TaO2, and SnO2. The results of these electrochemical measurements were confirmed by the surface investigations carried out by scanning electron microscopy (SEM) and energy dispersive spectroscopy (EDS). The results collectively proved that the uniform corrosion remarkably decreases with the increase in the Sn% and that the pitting corrosion is not likely to take place.