Influence of thermomechanical treatment on mechanical properties of CLAM steel

Abstract

To enhance the creep resistance of CLAM steel and thus elevate its maximum service temperature, in our prior research, a superior thermomechanical treatment process was developed based on thermal simulation experiments conducted. This study employed forging to achieve the desired thermal deformation in accordance with the superior thermomechanical treatment process, followed by mechanical property testing post tempering. Comparative analysis with normalized and tempered CLAM steel (N + T CLAM steel) revealed notable improvements in yield strengths ranging from 31–55 %, ultimate tensile strengths from 30–46 %, and a reduction in total elongations by 12–21 % at both room temperature and elevated temperatures. Additionally, the ductile-to-brittle transition temperature (DBTT) increased from -65 °C to -27 °C. Creep behavior of N + T CLAM steel exhibited similarities to other RAFM steels, with stress exponents measured at 500 °C, 550 °C, 600 °C, and 650 °C recorded as 16.5, 15.0, 10.2, and 7.8, respectively. The creep activation energy was determined to be 556 kJ/mol, closely aligning with results from Eurofer 97 steel and F82H steel, and approximately twice the self-diffusion activation energy of iron. The Larson-Miller parameter method was employed to forecast stress-rupture limits under various conditions, with a predicted result of 120 MPa under typical design life conditions (550 °C / 100,000 h) for the cladding module, comparable to Eurofer 97 steel and F82H steel. TMT CLAM steel exhibited a stress exponent of 16.7 at 550 °C, with a creep activation energy of 578 kJ/mol. Under typical design life conditions (550 °C / 100,000 h) for the cladding module, the predicted stress-rupture limit increased to 176 MPa, representing a 47 % improvement over N+T CLAM steel. Moreover, under the same conditions (550 °C / 230 MPa), the rupture time of TMT CLAM steel was 54 times longer than that of N+T CLAM steel.