Abstract
Porous ceramic pellets for possible environmental application were produced from different Latvian clays by sintering at different temperatures. Their characteristics and influence of additives were analysed using X-ray diffraction, mercury porosimetry and BET tests. The obtained ceramic pellets from calcareous clays after immersion in distilled water change its pH value, which affects their capability to adsorb ions or molecules on the surface. The sorption capabilities are dependent on the pH level of water solution, composition of clays, and used adsorbate. Porosity of the produced pellets is mostly within range from 15 to 25 % throughout all sintering temperatures with a slight decrease at 1050 ?C. The specific surface area has a wide range up to 30 m2/g. The highest surface area has pellets sintered at lower temperatures. The adsorption capability of pellets was evaluated using water solutions with different ions. The most promising results were obtained with iodine sorption. For most pellets the sorption capacity was 12.7 mg/g, although for the pellets sintered at 1050 ?C it was lower.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
