Abstract
Hot stamping is an attractive method to produce extra high strength automotive components. In the conventional hot stamping, the furnace heating is employed and the heating rate is quite low. To improve the productivity of the hot stamping technology, the reduction of time for the heating process is required. In this study, the influence of the heating rate in a range up to 200°C/s, heating temperatures between 650°C and 950°C and cooling condition on microstructure and mechanical properties of 0.22% C -3%Mn steel has been investigated. The steel is a promising material for the highly productive new hot stamping technology because this steel transformed into martensite from austenite even at cooling in free air. The specimens heat-treated at a high heating rate and for short holding time at the heating temperature just above Ac3 show significantly fine martensite microstructure and a good strength-toughness balance. In this paper, the α→ γ transformation behavior and the γ→ α transformation behavior after inter-critical annealing are discussed to explain the evolution of the microstructures and mechanical properties.
Sign-in/Register to access full text options 
Free) 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call
