Influence of the reaction conditions on the formation of Tl(Re)-Ba-Ca-Cu-O superconducting thin films by thallination in open system

Abstract

Abstract Rhenium avoids air degradation of the target as well as of precursor thin films during the preparation of high temperature Tl-based superconductors. Addition of Re has been used during synthesis of oriented Tl(Re)-Ba-Ca-Cu-O films. High temperature superconducting Tl-based thin films were prepared by a two step method combining RF magnetron sputtering and ex-situ thallination. Precursors with a composition of Re0.1Ba2Ca2Cu3Ox were deposited on a CeO2 buffered R-plane sapphire substrate. The sputtered films were prepared at room temperature in an Ar atmosphere. The thallination of the precursor films was performed in a one zone configuration, where both the pellet and precursor film were kept at the same temperature. The thallination temperature varied in the range of 850–880°C and samples were held for 30, 45 and 60 min at this temperature in a flowing oxygen atmosphere. Besides Tl-2212, X-ray diffraction reveals the possibility of also preparing the Tl-2223 phase, which was until now not reported in a Re doped form.