Abstract
The main aim of this research was to investigate the influence of different processing temperatures on the properties of pure poly-ether-ether-ketone (PEEK). In order to do this, we used a variation of compression moulding, which enabled us to use different processing temperatures, including temperatures below the melting point of PEEK. The PEEK samples were produced at temperatures below, around and above the melting point of PEEK and were compared to a commercially available PEEK material produced with a conventional procedure. The results of the dry-sliding tribological tests, the hardness measurements and the XRD analyses show that the processing temperature greatly influences the hardness and the crystallinity, which in turn affects the tribological behaviour.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
