Abstract
The paper aims to determine the influence of the process parameters, namely: C2H2 gas flow rate and inclination angle of the spraying gun on physico and mechanical properties of the hardalloyed layers of Diamax 10999 Eutalloy, on steel support - obtained by flame thermal spray process. For this purpose, the two technological parameters varied on three levels and in each case were evaluated the deposits properties. Investigations conducted by electronical microscopy SEM, X-ray, micro-hardness and by adherence evaluation and of the deposits porosity allowed the establishment of the performant deposit. Thus it was found that at the decreasing of the spraying distance,the deposit porosity decreases; in layer appear the phenomena of overheating, issue that determine the adherence reducing in average of 22%, and also the modification of chemical composition. The results recorded have afforded the obtaining of an optimum domain of variation of the process parameters.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: IOP Conference Series: Materials Science and Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
