Abstract
AbstractThe influence of oil type on the process yield, efficiency of encapsulation, particle size and morphological aspects of coacervated microparticles was investigated. Firstly, several factors affecting microencapsulation of oils by complex coacervation were simultaneously examined. The results indicated that the process yield is mainly dependent on the velocity of homogenization, temperature and polymer ratio. Using optimum conditions for producing microparticles [pH 4.0, 14,000 rpm, 50 °C, gelatin:gum arabic (GE:GA) 1:1 and 2.5 % w/v], different core materials were tested: a vegetable oil (almond oil), an oil with higher hydrophilic lipophilic balance (vetiver essential oil) and a highly hydrophobic oil (mineral oil). The oil phase exerted an influence on microparticle formation, disturbing the complexation of polymers and modifying the core distribution within the particles. Some of the polymers were complexed when mineral oil was used, and the highest efficiency of encapsulation (91.8 %) was obtained with vetiver oil, followed by the almond (70.6 %) and mineral (38.0 %) oils. Particles produced with vetiver oil were larger (43.5 μm) than those produced with mineral oil (35.0 μm) and almond oil (19.2 μm), and the increase in the size is due to the encapsulation of many small droplets of emulsion, characterizing these particles as multinucleate ones.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.