Abstract
The issues of the components of a grinding wheel recipe, namely, abrasive grains, bonds and various fillers on the cutting forces during grinding are considered in the article. The following types of fillers were studied: fused alumina microspheres, which are a non-burning hollow filler, glass microspheres used as a hollow melting filler, and a burning filler in the form of crushed fruit pits. On the basis of the obtained experimental data, generalized statistical models of the dependence of the magnitude of cutting forces during grinding on the percentage of grains, bond and fillers were developed. From the analysis of the pair correlation coefficients of the models of the grinding force components, it was concluded that the percentage of grains, bond, glass microspheres have the strongest effect on the cutting force sand the effect of fused alumina microspheres and fruit pits is negligible. Based on the results obtained, conclusions are formulated in the form of practical recommendations for reducing cutting forces.
Published Version (Free)
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.