Abstract
To keep optimally connected, all electrolysis cell elements is one of the most important design criteria. The optimal distribution of the clamping points is crucial to increasing cell performance. In this work, the compression pressure distribution inside of a 25 cm2 PEM electrolysis cell was evaluated, using different materials: Teflon®, Viton®, ethylene propylene diene monomer rubber (EPDM), and nitrile rubber. Sealing material evaluation was performed taking as performance indicators: total compressed area (%) and compression pressure, for different torques applied. Pressure distribution was obtained by using pressure-sensitive films, analyzing the distribution of pressure points from three-dimensional plots (3D), and quantifying intensities of the images obtained. Results showed that pressure points distribution depends on the stiffness and thickness of the gasket materials. For a tightening torque of 3.70 N m, a pressure of 2.23 MPa is obtained with 85% of the membrane area compressed using nitrile rubber-EPDM gaskets.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
