Influence of the alcohol and water grades on surfactant-free colloidal syntheses of gold nanoparticles in alkaline water-alcohol mixtures

Abstract

AbstractTo make the most of the unique properties of nanomaterials, and to bridge the gap between fundamental and applied research, controlled, green, cheap and energy efficient syntheses of nanoparticles are required. In this respect, room and low temperature surfactant-free colloidal syntheses of nanoparticles obtained in low viscosity and low boiling point solvents, without additives or nature-derived extracts, are promising to develop more active (electro)catalysts. Recently, a room temperature synthesis of surfactant-free gold nanoparticles has been documented (Chem. Mater. 2023, 35, 5, 2173) that requires only water, a base such as NaOH, an alcohol and HAuCl4. Unfortunately, the syntheses of nanomaterials are often sensitive to multiple parameters and it is well acknowledged that reproducibility is a general challenge in the chemical sciences, where the synthesis of nanomaterials is no exception. Here, we investigate the effect of the water conductivity and solvent grade on the surfactant-free low temperature (ca. 30 °C) synthesis of colloidal gold nanoparticles obtained in alkaline mixtures of ethanol and water. The synthesis can be performed with relatively low-grade ethanol but requires high purity water. The importance of water with low conductivity is also stressed for syntheses where ethylene glycol and glycerol are used as source of reducing agents. The results of this study over 100 samples pave the way to greener, more controlled and scalable syntheses of surfactant-free gold nanomaterials.