Influence of the addition of multi‐walled carbon nanotubes on the thermal and mechanical properties of polyamide‐11 before and after aging tests

Abstract

AbstractIn this work, the preparation and characterization of nanocomposites of commercial polyamide‐11 reinforced with multi‐walled carbon nanotubes (MWCNT), untreated, oxidized or with the modified surface through silanization with 3‐aminopropyl trimethoxy silane (APTMS), in concentrations of 0.1%, 0.5%, and 1.0 wt% in the polymer matrix was investigated. The processing of the nanocomposites was carried out via mixing in the molten state in a twin‐screw mini‐extruder at 200°C under 60 rpm screw rotation speed, with a residence time of 7 min. The addition of the MWCNT increased the thermal stability of PA11, predominantly with 0.5% of silanized nanotubes, as observed by the thermogravimetric analysis. X‐ray diffraction and differential scanning calorimetry analyses indicated that the degree of crystallinity of the formulations increased with the nanofiller content. On the other hand, the use of the highest concentration generated agglomerates, suggesting less dispersion in the matrix and, consequently, a reduction in crystallinity. Dynamic mechanical thermal analysis showed that the silanization process promoted an increase in both loss and storage moduli. All produced nanocomposites obtained values of corrected inherent viscosity above 1.20 dl/g, before and after the aging test. The use of lower load levels promoted better processability due to the lubricating effect of the nanotubes and an increase in the hydrophobic character of the samples, as observed by the increase of the contact angle.