Influence of temperature on wear performance of greases in rolling bearings

Abstract

Purpose Rolling bearing operation under mixed and boundary lubrication conditions may lead to heavy adhesive or abrasive wear, which may lead to wear-induced rolling bearing failure. The purpose of this paper is to investigate the wear protection capabilities of different grease compositions at varying temperatures. It is considered that the temperature influences the lubrication conditions, the behaviour of grease components, namely, bleed oil and thickener, as well as the tribofilm formation due to tribo-chemical interactions between additives and surfaces. Design/methodology/approach In this study, four different greases were produced on the basis of a mineral base oil by varying the thickener and the addition of ZDDP. Various grease-lubricated rolling bearing experiments were conducted in a wide temperature range from 0°C to 120°C. Subsequently, the wear pattern, tribofilm formation and grease structures were analysed. Thereby, the influence of the different grease thickeners and the performance of ZDDP as a common antiwear and extreme pressure additive was evaluated. Findings The results show a strong temperature-dependency and allow a classification of temperature ranges concerning wear protection. At low temperatures, all greases provide a very good wear protection without the evidence of additive-based tribofilm formation. In the experiments at elevated temperatures, ZDDP tribofilms were formed. The formation depends on the thickener type: in comparison to lithium thickener, polyurea thickener favours more protective tribofilms at the same temperature. The experimental results show that medium temperatures in the range of 40°C–60°C are critical concerning wear due to the insufficient tribolayer formation and limited load carrying capacity of the grease. Originality/value Temperature is a key operating parameter for grease lubrication in roller bearings. The experimental work enables consideration of different impact pathways of temperature by combining roller bearing tests and microanalysis.