Abstract
In this paper, we report the influence of temperature on the production characteristics of water-in-oil (W/O) emulsions by microchannel emulsification (MCE). The temperature of an emulsification module including a hydrophobic microchannel (MC) array chip was controlled between 10°C and 55°C. The continuous phase was a decane oil solution containing 5wt% tetraglycerin monolaurate condensed ricinoleic acid ester as a surfactant. The dispersed phase was a Milli-Q water solution containing 1wt% of sodium chloride and 5wt% of polyethylene glycol. The contact angle of the dispersed phase to the MC wall exceeded 152°, strongly suggesting that the MC array surfaces are not wetted by the dispersed phase during MCE. At the breakthrough pressure of the dispersed phase, monodisperse W/O emulsions with coefficient of variation below 5% were produced via hydrophobic MC arrays, irrespective of the temperature. At each operating temperature, the resultant droplet diameter was also almost constant below a critical flow velocity of the dispersed phase. The maximum droplet generation rate from a channel gradually increased with increasing operating temperature due to the decrease in viscosity of both phases. An adapted capillary number that considers the influence of the wettability and surfactant adsorption had a low maximum/minimum value ratio of 1.2.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Colloids and Surfaces A: Physicochemical and Engineering Aspects
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
