Influence of temperature and light intensity on the photocuring process and kinetics parameters of a pigmented UV curable system

Abstract

The photopolymerization of pigmented coatings is a great challenge and hardly investigated in the literature. Therefore, in this work, the effect of photopolymerization temperature and light intensity on the curing behavior of a TiO2-pigmented UV curable epoxy acrylate system was investigated by using photo-differential scanning calorimetry (photo-DSC) analysis. The rate of conversion and ultimate conversion at four different temperatures (i.e., 25, 45, 65, and 85 °C) and four light intensities (i.e. 2, 20, 40 and 80 mW cm−2) for unpigmented and pigmented formulations were measured. The effect of photo-polymerization temperature and light intensity on the kinetics constants was also evaluated. It was observed that the rate of conversion and final conversion values were affected by the temperature and UV-light intensity. It was seen that the rate of conversion and ultimate conversion had their maximum values at 65 °C for unpigmented formulations. However, in pigmented formulations, these two parameters improved by increasing the temperature even up to 85 °C. Increasing the temperature caused an increase in the amount of propagation and termination rate constants in both pigmented and unpigmented formulations although the changes in the pigmented formulation were more pronounced. It was observed that the rate of polymerization and ultimate conversion for unpigmented formulations increased by increasing the light intensity up to 20 mW cm−2 and then decreased. On the other hand, it was found that these two parameters increased by increasing light intensity up to 40 mW cm−2 when pigmented formulations used. Finally, the dependence of termination and propagation kinetics constants on light intensity was established for both unpigmented and pigmented coatings.