Influence of T5 heat treatment on the microstructure and lubricated wear behavior of ternary ZnAl40Cu2 and quaternary ZnAl40Cu2Si2.5 alloys

Abstract

AbstractA ternary ZnAl40Cu2 and a quaternary ZnAl40Cu2Si2.5 alloys were produced by permanent mold casting and subjected to T5 heat treatment at a temperature of 150 °C for 24 hours. The structural, mechanical and lubricated wear properties of these alloys were investigated in the as‐cast and heat‐treated conditions and the results were compared with those of SAE 65 (CuSn12) plain bearing bronze. Microstructure of the ternary alloy consisted of aluminum‐rich α, eutectoid conversion product of α+η and ϵ phase located in the interdendritic channels. In addition to these phases, silicon particles were observed in the microstructure of the quaternary alloy. T5 heat treatment caused a considerable amount of reduction in the hardness, tensile strength and wear resistance of ZnAl40‐based ternary and quaternary alloys, but improved their ductility and stability. These alloys in the as‐cast and heat‐treated conditions exhibited lower wear volume or higher wear resistance than SAE 65 bearing bronze. Among the experimental alloys, the optimum mechanical properties and wear performance were obtained from ZnAl40Cu2Si2.5 alloy in both as‐cast and heat‐treated conditions. Adhesion appeared to be the main wear mechanism for the ZnAl40‐based alloys, but abrasion dominated the wear of SAE 65 bronze.