Influence of Synthetic Concentration on Surface Properties of SnO<sub>2</sub> Nanofilm by Hydrothermal Method

Abstract

Dye-sensitized solar cells have better development prospects than silicon cells, and their main structural composition of nanoporous semiconductor films is particularly important. It is the tin dioxide film, and the effect of preparing tin oxide film on dye-sensitized solar cells under different conditions is studied. In this paper, the SnO2 powder was prepared by hydrothermal method, and the experiment was studied by controlled variable method. The properties of the obtained tin dioxide powder were characterized by SEM and three-dimensional ultra-depth microscope and XRD. The XRD diffraction peak is shown as tetragonal phase rutile type SnO2, With the increase of the concentration of tin tetrachloride solution, the coarser the particle size of the tin oxide crystal in the film, the more complicated the surface morphology, so that the specific surface area of the film is larger. At 0.1 mol/L, the surface of the film is a porous structure in the form of a loose sheet is presented. After analyzing the surface microstructure and flatness of the tin dioxide film, it can be concluded that the effect of salt concentration on the specific surface area of the film is extremely large. When the salt concentration is higher or lower, the obtained two the surface of the tin oxide film is relatively flat and has poor performance. When the salt concentration is 0.1mol/L, the surface of the obtained film has a large undulation and a large specific surface area, and the ability to adsorb the dye molecules can be predicted to be the greatest, and the photoelectric conversion efficiency is optimal in the photocatalytic process.