Abstract
Behaviour of volatile compounds in gin distillation using a batch column laboratory still has been investigated altering distillation parameters such as reflux strategy, pressure, and still design (column configuration). The distillate was separated into four equal fractions and ten volatile terpenes were quantified. Experimental values were compared to calculated data using a dynamic model calculated with ProSim BatchColumn software using a non-random two-liquid model to describe the interaction between solvents and terpenes. In the simulation different terpenes were considered and clustered into three group profiles. The monoterpene group was found to be the most volatile resulting in the highest concentration in the first fraction and depleting towards the end. The oxygenated terpenes increased in concentration with depleting ethanol concentration in the still and were therefore the least volatile compounds whereas the two representatives of the sesquiterpenes were found to be semi volatile. Changes in the column configuration resulted in major differences in the total concentration of terpenes extracted. The change of reflux strategy resulted in a higher concentration of the more volatile fraction at the higher reflux ratio chosen. The model showed a moderate agreement with the experimental data and only the monoterpenes considered showed good agreement.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.