Abstract
This article describes the interacting of AISI 304L stainless steel circular pipes automatic and manual TIG welding method and its parameters to the process accuracy and productivity. Pipe edge preparation described applying seam sequence for manual welding. Length of samples deformation is analyzed and their axial deviation after automatic and manual welding is determined. Basing and measurement principal schemes are presented. The results of measurements are systematized applying appropriate tables with presenting the results analysis. The research is based on experimental results and measurements deleting axial deviation of welded pipes after manual and automatic welding. Looking of best productivity index and welding quality the optimal welding speed and other parameters have been defined experimentally. Further research discusses the possibilities of improvement the productivity index increasing created product and process value. DOI: http://dx.doi.org/10.5755/j01.mech.19.2.4161
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callSimilar Papers
More From: Mechanika
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
