Influence of Processing Conditions on the Generation of Surface Defects in a Heat-and-Cool Hybrid Injection Molding Technique for Carbon Fiber-Reinforced Thermoplastic Sheets and Development of a Suitable Mold Heated by Far-Infrared Radiation.

Abstract

Recently, hybrid injection molding-a type of overmolding technology in which a short carbon fiber-reinforced thermoplastic is injection molded over a compression-molded carbon fiber-reinforced thermoplastic (CFRTP) sheet-has been introduced. A heat-and-cool hybrid injection molding technique has also been introduced for practical use. The technique yields high-quality molded products. This is achieved through the heating of the mold cavity surface to a temperature higher than the melting point of the base polymer impregnated into the carbon fiber fabric. However, few experimental analyses of the molding phenomena in heat-and-cool hybrid injection molding have been reported. In particular, the effect of the processing conditions on the transfer of the mold cavity surface shape to the CFRTP sheet has not been clarified in detail. Therefore, it has been impossible to take extensive measures when defects are generated in molded products. In this study, a mold is designed and fabricated for use with far-infrared radiation heating, a variotherm technology that is suitable for the experimental analysis of the heat-and-cool hybrid injection molding phenomenon. In particular, a mold is designed and fabricated to continuously perform the following three processes using only an injection molding machine: (1) the radiation heating of both the CFRTP sheet and the mold cavity surface using a far-infrared radiation heater, (2) the compression molding of the CFRTP sheet, and (3) the injection molding of the melt. The effects of the heating conditions of the mold and the injection molding process conditions on the appearance characteristics of the molded products are clarified using this mold and a far-infrared radiation heater.