Influence of printing parameters on the stability of deposited beads in fused filament fabrication of poly(lactic) acid

Abstract

Fused filament fabrication (FFF) is one of the various types of additive manufacturing processes. Similar to other types, FFF enables free-form fabrication and optimised structures by using polymeric filaments as the raw material. This work aims to optimise the printing conditions of the FFF process based on reliable properties, such as printing parameters and physical properties of polymers. The selected polymer is poly(lactic) acid (PLA), which is a biodegradable thermoplastic polyester derived from corn starch and is one of the most common polymers in the FFF process. Firstly, the maximum inlet velocity of the filament in the liquefier was empirically determined according to process parameters, such as feed rate, nozzle diameter and dimensions of the deposited segment. Secondly, the rheological behaviour of the PLA, including the velocity field, shear rate and viscosity distribution in the nozzle, was determined via analytical study and numerical simulation. Our results indicated the variation in the shear rate according to the diameter of the nozzle and the inlet velocity. The shear rate attained its maximum value near the internal wall at high inlet velocities and smaller diameters. Finally, the distribution of the viscosity along the radius of the nozzle was obtained. At high inlet velocity, several defects appeared at the surface of the extrudates. At the highest shear rates, the extrudates underwent severe deformation. The defects predicted via numerical simulation were reasonably consistent with that observed from an optical microscope. Hence, these results are effective for selecting the printing parameters (i.e. nozzle diameter, feed rate and layer height) to improve the quality of the manufactured parts.