Abstract
The paper presents the results of a computer simulation illustrating the influence of power losses in the core of an inductor based on the characteristics of buck and boost converters. In the computations, the authors’ model of power losses in the core is used. Correctness of this model is verified experimentally for three different magnetic materials. Computations are performed with the use of this model and the Excel software for inductors including cores made of ferrite, powdered iron, and nanocrystalline material in a wide range of load resistance, as well as input voltage of both the considered converters operating at different values of switching frequency. The obtained computation results show that power losses in the inductor core and watt-hour efficiency of converters strongly depend on the material used to make this core, in addition to the input voltage and parameters of the control signal and load resistance of the considered converters. The obtained results of watt-hour efficiency of the considered direct current (DC)–DC converters show that it changes up to 30 times in the considered ranges of the mentioned factors. In turn, in the same operating conditions, values of power losses in the considered cores change from a fraction of a watt to tens of watts. The paper also considers the issue of which material should be used to construct the inductor core in order to obtain the highest value of watt-hour efficiency at selected operation conditions of the considered converters.
Highlights
Direct current (DC)–DC converters, which are used, e.g., in switch mode power supplies and semiconductor devices, contain magnetic elements used to store electrical energy [1]
In order to verify the influence of power losses in the inductor core on selected DC–DC converters, computations using the model presented in Reference [3] and described by Equations (3)–(6) were performed with the Excel software
The accuracy of the calculations is limited by the accuracy of the used models of power losses in the inductor core and by the model DC–DC converter characteristics
Summary
Direct current (DC)–DC converters, which are used, e.g., in switch mode power supplies and semiconductor devices, contain magnetic elements used to store electrical energy [1]. In previous studies [13,16,17,18,19], the methods for computing power losses in magnetic materials based on modifications of the Steinmetz model, defined as improved Steinmetz equation (ISE) or modified Steinmetz equation (MSE), were presented. In these models, the shape of the waveform of the excitation signal is taken into account; the influence of temperature on the properties of magnetic materials and on the parameters of the considered model is not taken into account. In the presented research results, among others, ferrite materials such as N87 were used, whose properties
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.