Abstract
Cold sintering parameters such as, temperature, pressure, aqueous phase, heating rate and dwelling time has been widely discussed in the literature but the role of starting powder with respective microstructure development is mostly overlooked. There is a need for understanding the effect of powder agglomerates and the role of inter particle friction on the densification behavior during cold sintering process. Present study encompasses investigation and optimization of these parameters for ZnO which enabled > 99 % of relative density with grain sizes below 200 nm. Additionally, role of external atmosphere was also studied to investigate its impact on densification during the process. All cold sintering experiments were carried out in a FAST/SPS device for studying aqueous phase evaporation and ensuring the reproducibility of process parameters. Microstructure characterization (scanning and transmission electron microscopy) showed – without any post heat treatment– defect free grain boundary structure opposite to what documented by previous studies.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
