Abstract
Fine powder of cubic Y 2O 3:Eu phosphor was synthesized and simultaneously deposited on fused silica slides by low-temperature flame-assisted spray pyrolysis in premixed propane/air flames. By adding ethylene glycol and citric acid to the precursor solution, morphology of phosphor particles could be improved. The intensity of the photoluminescence (PL)-emission of the phosphor screens deposited by the modified technique, when excited by ultraviolet (UV)-light with the wavelength of 254 nm, did not exceed that of the screens deposited without the polymeric additives. However, in vacuum UV, phosphors produced with the addition of polymers perform significantly better than the ordinary “no-polymer” FASP-coatings.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.