Influence of Plasticizers and Drugs on the Physical-Mechanical Properties of Hydroxypropylcellulose Films Prepared by Hot Melt Extrusion

Abstract

Hydroxypropylcellulose (HPC) films containing drugs or hydrophilic or hydrophobic plasticizers were prepared by a hot melt extrusion process. Polyethylene glycol 8000 (PEG 8000) 2%, triethyl citrate (TEC) 2%, acetyltributyl citrate (ATBC) 2%, and polyethylene glycol 400 (PEG 400) 1% were the plasticizing agents studied. In addition, either hydrocortisone (HC) 1% or chlorpheniramine maleate (CPM) 1% was incorporated into the films as a model drug. The physical-mechanical properties of the films that were investigated included tensile strength (TS), percentage elongation (%E), and Young's modulus (YM). Differential scanning calorimetry (DSC) was utilized to determine glass transition temperatures (Tg' s). These parameters were studied as a function of time and temperature. The glass transition temperatures initially decreased with the inclusion of the drugs and plasticizers. However, after 6 months aging, films containing PEG 400 and HC showed a marked increase in Tg. The films containing PEG 400 showed physical-mechanical instability in all parameters studied. All extruded films exhibited a marked decrease in TS in contrast to a large increase in %E when testing was performed perpendicular to flow versus in the direction of flow. In addition, a consistent film of HPC in the absence of drugs or plasticizers could not be extruded due to the excessive stress on the equipment. Although the theoretical percentage of CPM on aging remained fairly constant over the processing temperature ranges in this study, the HC levels remaining in the extruded films during storage were a function of time and temperature.