Abstract
In this study, we investigated cold-sprayed copper as a front contact for crystalline silicon solar cells. Copper powder was deposited on a monocrystalline silicon wafer with variation of the particle velocity during deposition. The particle velocity was varied by varying the heating temperature from 250 to 400 °C using a gas pressure of 0.45 MPa. The particle velocities were calculated using empirical equations, and were found to increase with an increase in the carrier gas temperature. Grid patterns were formed on a phosphorus-doped n-type emitter of a p-type silicon substrate. The electrode thickness increased with increasing particle velocity. The electrical properties of the grids were evaluated using the transfer length method. The specific contact resistance of the n-type emitter was in the range of 2.6-26.4 mΩ-cm2. Damage to the p-n junction was investigated via minority carrier lifetime measurement of the substrate. The copper-silicon interface was evaluated using transmission electron microscopy. The contact properties were affected by the interface conditions.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
