Abstract
Laser powder bed fusion (LPBF) additive manufacturing technology is sensitive to variations in powder particle morphology and size distribution. However, the absence of a clear link between the powder characteristics and the LPBF performances complicates the development, selection and quality control of LPBF powder feedstock. In this work, three Ti-6Al-4 V powder lots produced by two different techniques, namely, plasma atomization and gas atomization, were selected and characterized. Following the micro-computed tomography analysis of the powder particles’ morphology, size and density, the flowability of these powder lots was concurrently evaluated using Hall and Gustavsson flowmeters and an FT4 powder rheometer. Using established rheology-based criteria, a figure of merit was proposed to quantify the overall powder suitability for the LPBF process. Next, the same three powder lots were used to 3D-print and post-process a series of testing specimens with different layer thicknesses and build orientations, in order to establish a correlation between the powder characteristics and the geometric and mechanical properties of a final product. This study demonstrates that the use of highly spherical powders with a limited amount of fine particles promotes their flowability and yields LPBF components with improved mechanical and geometric characteristics.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
