Influence of Ni content on the structure and properties of Cr–Ni–N coatings prepared by direct current magnetron sputtering

Abstract

Cr–Ni–N coatings were deposited on 304 stainless steel substrates using a conventional direct current magnetron reactive sputtering system in nitrogen–argon reactive gas mixtures. The influence of Ni content (0 ≦ x ≦ 20 at.%) on the coating composition, microstructure, and tribological properties was investigated by glow discharge optical spectroscopy, X-ray diffraction and transmission electron microscopy, scanning electron microscopy (SEM), nano-indentation, and pin-on-disk tests. The results showed that microstructure and properties of coatings changed due to the introduction of Ni. The ternary Cr–Ni–N coatings exhibited solid solution structures in spite of the different compositions. The addition of Ni strongly favoured preferred orientation growth of <200>. This preferred orientation resulted from the formed nano-columns being composed of grains with the same crystallographic orientation, as confirmed by SEM cross-sectional observations. The mechanical properties including the nano-hardness and reduced Young's modulus decreased with increasing Ni content. Pin-on-disk tests showed that low Ni content coatings presented higher abrasion resistance than high Ni content coatings.