Abstract

In this article, monomers (tannic acid (TA) and m- phenylenediamine (MPD)) were used in the fabrication of a novel PES based thin-film composite nanofiltration (TFC-NF) membrane for the treatment of a common effluent treatment plant (CETP) of textile industrial wastewater. PES support sheets and TFC layers were fabricated via non-solvent induced phase inversion and in-situ interfacial polymerization (IP) process. The ultra-thin active layer was synthesized via the IP process with monomers such as tannic acid (TA) and m- phenylenediamine (MPD). T and M series membranes correspond to (PES/x wt% TA, x = 2, 4, 6) as T1, T2, T3 -TA and (PES/x wt% MPD, x = 2, 4, 6) as M1, M2, M3-MPD respectively. M0 corresponds to PES which is the virgin membrane. The chemical structure, surface morphology, surface roughness and surface properties were explored using fourier transform infrared (FTIR) spectroscopy, field emission scanning electron microscopy (FESEM), atomic force microscopy (AFM) and contact angle, respectively. The filtration performance of the thin-film composite nanofiltration (TFC-NF) membranes was investigated by various properties like pure water flux, salt rejection, porosity, mean pore radius and antifouling analysis. T1-TA membrane showed better water permeability, high salt rejection and better industrial effluent rejection with 94.4% of TDS that are suitable for industrial reuse and agricultural irrigation. Moreover, for T1-TA membrane, the water flux, porosity, mean pore radius, salt rejection, surface roughness and contact angle of 43.5lm- 2 h - 1, 47.1%, 16.7nm, 72.7%, 11.7nm and 41.48°was achieved respectively that was found to be higher than that of all the other fabricated membranes. Further, the rejection efficiency rate of textile effluent characteristics such as pH, turbidity, TDS, alkalinity, total hardness, BOD and COD were also achieved with maximum deduction in the T1-TA TFC-NF membrane compared to the M0-Virgin PES membrane. From the results, it can be confirmed that the T1-TA membrane significantly reduced the alkalinity, total hardness, BOD and COD rejections of 78%, 77.3%, 58.5% and 67.5% respectively, present in the effluent. Water flux recovery ratio (FRR) was improved from 74.6% for M0-Virgin PES membrane to 94.8% for T1-TA membrane. The modified TFC-NF membranes especially T1-TA, had better anti-fouling property and excellent hydrophilicity than the unmodified M0-Virgin PES membrane. The online version contains supplementary material available at 10.1007/s40201-021-00624-x.

Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call